Despatch MIC1462 Controller Manual Instrukcja Użytkownika Pobierz pdf (Strona 47)

6.2 Parameters Common To All Programs

(Program Number = A, Segment Number = Blank)

The parameters common to all programs (global parameters) are presented for

editing/viewing in the following sequence:

Table 6-1 Global Profile Parameters

STEP

DESCRIPTION MESSAGE

DISPLAY

FUNCTION AVAILABLE SETTING

1 Start On Start On Defines setpoint value at

start of each program

SEtP - Current Controller setpoint

value

Proc - Current Process variable

value

2 Go To Go To Defines Base Mode Status

and end of each program

On - Outputs are active

Off - Outputs are inactive

3 End On End on Defines setpoint value at

end of each program

F_SP-End on Final SP value*

SEtP-End on Controller SP value

4 Delay Time Delay Defines delay (in

hours/min) between

initiating the program and

actually starting

Numerical value, with the decimal

point separating the hours and

minutes.

5 Program Lock LockProg Defines whether the

operator is permitted to

change program

definitions while a program

is running/held

On - No changes permitted

Off - changes permitted

6 Power Fail

Recovery

Period

Recovery Defines length of power

loss before automatic

return to Base Mode after

restoration of power,

regardless of Recovery

Type.

1:00 - 24:59

NOTE: If the real time clock

option has not been provided,

changing this value to 0.01 will

allow selection of Recovery Type.

Setting this to 00:00 will force a

return to Base Mode.

7 Power Fail

Recovery Type

Rec Type Defines response to

restoration of power after a

power loss. This

parameter does not

appear if Recovery is set

to 0.00. These settings

can be overridden by the

Recovery parameter.

cont - Continue with mode of

operation at time of power failure.

rESt - Restart program running at

time of power failure. If one was

not running, return to Base Mode.

PFH - Setpoint and event outputs

are held at values at time of

power loss. P.F. Hold is

displayed until a key other than

RUN/HOLD is pressed. Pressing

the RUN/HOLD key will continue

the profile if one was running.

Holding this key for more than five

seconds will abort the profile.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 111 112

Komentarze do niniejszej Instrukcji

Brak uwag

Despatch MIC1462 Controller Manual Instrukcja Użytkownika Strona 47

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Panel sterowania Despatch MIC1462 Controller Manual